Theta
THETA is a vertical lifting platform. Because it is a telescopic type, its volume is smaller and its weight is lighter. It also uses a synchronous belt slide table and a brushless servo acceleration motor, with stable lifting and lower noise. Multiple communication interfaces meet various development needs.
Safety Instructions
Important Safety Information
- Hot-plugging electrical connections while the device is powered on is strictly prohibited.
- Unless there is an emergency, ensure the device is stationary before powering it off. Do not power it off during movement.
- Do not use the device while it is charging.
- Confirm the device's operating voltage, power, installation, and other parameters before use. Damage caused by exceeding these parameters is not covered under warranty.
- Assess the required IP rating, temperature range, and environmental suitability. Damage caused by harsh operating conditions is not covered under warranty.
- This device does not provide collision prevention, fall prevention, or proximity warning functions. Conduct a safety assessment of the integrated product and comply with applicable regulations and certifications to prevent major safety hazards.
- Read the maintenance requirements to prevent irreversible damage caused by incorrect operation, such as battery over-discharge, wheel hub damage due to low tire pressure, or shaft wear due to insufficient lubrication.
- For first-time use, place the unloaded device in a safe, open area. Start it according to the operating instructions and test all functions. Contact your supplier if any problem occurs.
- If the device behaves abnormally or an accident occurs, immediately press the emergency stop or turn off the power to prevent further damage. Contact technical support and do not disassemble the device yourself. Note: Damage caused by unauthorized disassembly, modification, misuse, natural disasters, or other force majeure events is not covered under warranty. The manufacturer assumes no responsibility for safety incidents involving user-integrated equipment. Users must conduct their own risk assessments and reliability testing.
Technical Specifications
| Parameter | Specification |
|---|---|
| Max Lifting Speed | 0.24m/s |
| Lifting Load | 20kg |
| Movement Type | Rail Slide |
| Lifting Motor | 400W Brushless Servo Motor |
| Communication Interface | Ethernet + USB |
| Operating Voltage | 48V |
| Brake | Mechanical Holding Brake |
| Power Input | 48V |
| Stroke | 0.42m |
| Emergency Stop Switch | Mechanical E-Stop Button Installed |
| LAN Broadcast/Shared E-Stop Status | Yes/Supported |
| Motor Command Timeout Protection | Yes |
Robot Dimension Diagram
Quick Start
Software Usage
Please refer to API Control